×
Login Form
×
Registration
Profile Informations
Login Datas
or login
Details
Unique AR's Molon Labe 12" Free Float Forend. This precision forend creates a finished off look for your AR with a perfect balance of form and function.
Color: Black
For AR15 Rifles
AR15 Free-float handguard made of 6061 T6 Aluminum. Inside diameter 1.75″, exterior diameter 2″.
Compatible with any mil-spec upper.
Unique-ARs provides a lifetime limited warranty on all free float forends and tac rail. They warranty all materials and finishes will be free from defect. They want you to be more then satisfied with your precision parts and our customer service.They will do thier best to make your experience dealing with our company a positive one, however they do not cover stripped or abused parts. Give the, a call if you have any questions, Unique AR's 888.982.8386.
Mounting Instructions and Tips: Step: 1) Once you have the old free float-tube and/or barrel nut removed, clean any grease or oil from the threads of the upper receiver extension.
Step: 2) Apply a drop or two of blue LocTite® to the receiver threads and screw the large aluminum barrel-nut on until it stops, then back it off until the gas tube holes line up.
Step: 3) Insert the barrel and slide the steel castle bolt over the barrel and thread it into the aluminum barrel-nut; now, use a punch to to keep the gas tube holes aligned .
Step 4) With the punch inserted in the gas tube holes turn the steel castle bolt by hand until you get a good, solid hand-tight alignment with the barrel-nut and receiver. Once you have the two aligned, let it set for a 2-24 hours ; after the blue LocTite® has cured between the barrel-nut and receiver, the steel insert and barrel can be removed.
Step 5) For final assembly insert the barrel, thread the steel castle bolt into the barrel-nut and once it is finger tight, back it off three or four turns and place a drop of blue LocTite® on the threads of the steel insert, right where it becomes visible out of the barrel-nut.
Step 6) Now torque the steel insert down to desired torque. This can all be accomplished with or without the use of punch in the gas tube but the barrel-nut can move while you are torquing the steel castle nut, and then you will have to loosen it up and re-time it. We recommend using the punch to insure proper timing.
Step 7) Once you have installed the gas tube, slide the handguard onto the barrel nut and aligned the 6 radial holes with the corresponding holes in the barrel-nut, the 6 countersunk screws can be installed. For 308 barrel nuts it is important that screws are installed in the proper location TOP,MIDDLE, BOTTOM Inserting screws into the wrong hole will damage the barrel nut. Tighten until snug. DO NOT over tighten. Stripped screws are not covered by the warranty.
Additional Information
Manufacturer | Unique AR'S |
---|---|
Free Shipping | Yes |
Country of Manufacture | United States |
UPC | No |